Tribute 4WD L4-2.5L Hybrid (2009)
3. Adjust the CKP sensor with the alignment tool.
-
Tighten to 7 Nm {0.7 kgf-m, 62 in-lbf}.
NOTE:The crankshaft position (CKP) sensor alignment tool is supplied with the new sensor and is not available separately.
4. Connect the CKP sensor electrical connector.
5. Remove the 6 mm (0.23 in) bolt from the crankshaft pulley.
6. Install the engine plug bolt.
-
Tighten to 20 Nm {2.0 kgf-m, 177 in-lbf}.
7. Install the RH splash shield and the 5 bolts.
-
Tighten to 9 Nm {0.9 kgf-m, 80 in-lbf}.
8. Using the scan tool, carry out the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.
