Tribute 4WD L4-2.5L Hybrid (2009)
7. Within 2 minutes of the horn sounding, place the activation tool on the RF tire sidewall at the valve stem and release the button to train the RF tire
pressure sensor.
8. Repeat Step 7 for the RR and LR tires.
NOTE:The procedure is completed after the last tire has been trained. When the training procedure is complete, the message center (if equipped) will
display "TIRE TRAINING COMPLETE". For vehicles not equipped with a message center, successful completion of the training procedure will be
verified by turning the ignition switch to the OFF position without the horn sounding. If the horn sounds when the switch is turned to the OFF position,
the training procedure was not successful.
NOTE:Do not wait more than 2 minutes between training each sensor or the SJB will time out and the entire procedure must be repeated.
9. Using the scan tool, locate the updated TPMS sensor identifiers trained to the SJB and document them on the applicable warranty claim.
10. If the sensors are being trained due to the installation of a new SJB, clear any DTCs and carry out the SJB On-Demand Self-Test.
NOTE:This step is required to clear DTC C2780, causing the SJB to exit the manufacturing mode and to make sure there are no other concerns with a
newly programmed SJB.
