Tribute 4WD L4-2.5L Hybrid (2009)
Stabilizer Bushing: Service and Repair
STABILIZER BAR BUSHING REMOVAL/INSTALLATION
CAUTION:When installing the stabilizer bar bushings, make sure the bushings are correctly oriented with the bushing flanges in the up position and the
bushing split pointing to the front of the vehicle.
1. With the vehicle in NEUTRAL, position it on a hoist. See See: Wheels and Tires/Vehicle Lifting/Service and Repair/Lifting.
2. Remove the 2 bolts and the stabilizer bar bushing bracket.
-
To install, tighten to 70 Nm {7.0 kgf-m, 52 ft-lbf}.
3. Remove the stabilizer bar bushing.
NOTE:Inspect the stabilizer bar bushing for wear. If necessary, install a new part.
4. To install, reverse the removal procedure.