Tribute 4WD L4-2.5L Hybrid (2009)
15. Remove the selector lever cable end from the manual lever, remove the selector lever cable bracket nuts and remove the selector lever cable
assembly.
-
Tighten to 22 Nm {2.2 kgf-m, 16 ft-lbf}.
16. Place the manual lever in DRIVE, by positioning the manual lever between the 2 ribs on the transaxle case.
To install, reverse the removal procedure.
NOTE:Before installation, make sure the manual lever is in the DRIVE position with the ignition in the OFF position or the selector lever cable will
have to be adjusted.
