Tribute DX 2WD L4-2.0L (2001)
15. Disconnect the driver air bag module electrical connector.
16. Connect the special tool to the steering column harness side of the driver air bag module electrical connector.
17. Connect the battery ground cable.
18. Prove out the air bag system. For additional information, see AIR BAG AND SAFETY BELT PRETENSIONER SUPPLEMENTAL
RESTRAINT SYSTEM (SRS).
19. Remove the seat track to floor nuts.
20. Position the driver seat rearward.
21. If equipped with power seats, disconnect the negative battery cable.
CAUTION: Use care when handling the seat and track assembly. Dropping the assembly or sitting on a seat not secured in the vehicle may result
in damaged components.
