Tribute DX 2WD L4-2.0L (2001)
3. Connect the seat cushion trim cover J-clips.
CAUTION: Use care when handling the seat and track assembly. Dropping the assembly or sitting on a seat not secured in the vehicle may result
in damaged components.
4. Install the driver seat.
1. Position the driver seat.
2. Install the seat track to floor bolts.
3. If equipped with power seats, connect the electrical connector.
5. If equipped with power seats, connect the battery ground cable.
6. Position the driver seat forward.
7. Install the seat track to floor nuts.
8. If equipped with power seats, disconnect the battery ground cable and wait one minute.
Vehicles with side air bag
WARNING: The air bag is for restraint system service only. Remove from vehicle prior to road use. Failure to remove could result in
injury and possible violation of vehicle safety standards.
