Tribute DX 4WD L4-2.0L (2001)
16. Connect the special tool to the steering column harness side of the driver air bag module electrical connector.
17. Connect the battery ground cable.
18. Prove out the air bag system. For additional information, see AIR BAG AND SAFETY BELT PRETENSIONER SUPPLEMENTAL
RESTRAINT SYSTEM (SRS).
19. Remove the seat track to floor nuts.
20. Position the driver seat rearward.
21. if equipped with power seats, disconnect the negative battery cable.
CAUTION: Use care when handling the seat and track assembly. Dropping the assembly or sitting on a seat not secured in the vehicle may result
in damaged components.
22. Remove the driver seat.
1. If equipped with power seats, disconnect the electrical connector.
2. Remove the seat track to floor bolts.
3. Remove the driver seat.
Installation
WARNING: Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag
module. This will reduce the risk of injury in the event of an accidental deployment.
WARNING: Carry a live side air bag module with the air bag and tear seam pointed away from your body. This will reduce the risk of injury
in the event of an accidental deployment.
WARNING: Do not set a live side air bag module down on the cover tear seam. This will reduce the risk of injury in the event of an accidental
