Tribute DX 4WD L4-2.0L (2001)
NOTE:
DO NOT use anything sharp such as a screwdriver, awl or punch that could penetrate the seal and allow moisture to enter the terminal.
2.
Reinstall dress cover and use electrical tape to secure the cover at the same location where the original tie strap was removed. Apply dielectric
grease to the ABS module connector, position and connect the harness as follows:
a)
Reinstall dress cover.
b)
Use ONLY dielectric grease.
^
With the tip of the applicator tube snipped off, position the end of the tip between the four (4) large flat pins at the bottom of the ABS module
connector. Squeeze out enough grease to completely cover the four (4) flat pins.
NOTE:
DO NOT spread the grease around the connector. Applying an excess amount of grease into the connector cavity will cause a "hydro lock"
condition which will not allow the connector to fully seat or lock in place.