Tribute DX 4WD L4-2.0L (2001)
Valve Cover: Service and Repair
VALVE COVER
Removal and Installation
1. Remove the air cleaner outlet pipe.
2. Remove the ignition wires from the spark plugs.
3. Disconnect the throttle cables.
1. Disconnect the cruise control actuator cable (if equipped).
2. Disconnect the accelerator cable.
4. Remove the valve cover.
1. Remove the studbolts
2. Remove the bolts.
Caution: The valve cover sealing surfaces are soft materials. Do not use abrasive grinding discs to remove gasket material; only use manual
scrapers. Do not scratch or gouge sealing surfaces or oil leaks may occur.
5. Clean and inspect the sealing surfaces of the valve cover and the cylinder head. Both surfaces must be clean and flat.
6. To install, reverse the removal procedure.
1. Install a new valve cover gasket if damaged.
