Tribute DX 4WD L4-2.0L (2001)
Air Door Cable: Service and Repair
TEMPERATURE BLEND DOOR CONTROL CABLE
Removal and Installation
1. Disconnect the negative battery cable.
2. Lower the glove compartment.
1. Press the glove compartment release tabs inward while pulling downward on the glove compartment door.
3. Disconnect the temperature blend door control cable.
1. Align the locator holes and insert the special tool.
2. Release the locking tab.
3. Remove the temperature blend door control cable from the blend door shaft.
4. Remove the instrument cluster finish panel.
1. Remove the two screws.
2. Remove the instrument cluster finish panel and disconnect the electrical connectors.
