Tribute DX 4WD L4-2.0L (2001)
Transmission Speed Sensor: Service and Repair
Turbine Shaft Speed (TSS) Sensor
Removal
1. Raise and support the vehicle.
2. Remove the LH front wheel.
3. Remove the splash shield.
4. Place a drain pan beneath the turbine shaft speed (TSS) sensor.
5. Remove the TSS sensor.
1
Disconnect the TSS sensor electrical connector.
2
Remove the bolt.
3
Inspect the TSS sensor bore.
6. Inspect the O-ring seal for nicks or cuts. Install a new seal as necessary.
Installation
Note: Apply a light coat of petroleum jelly to the O-ring seal before installation.