Tribute DX 4WD V6-3.0L DOHC (2002)
NOTE:
Inside cabin needs to be accessed from an alternate door to begin procedure.
1.
Move the front seat(s) to center position and the affected door glass completely down.
2.
Disconnect the battery negative cable and wait at least one minute.
3.
Lower the glove compartment by depressing the locking tabs. Disconnect the passenger air bag module electrical connector and connect the
special tool (418-F468) to the instrument panel harness side of the passenger air bag module electrical connector.
4.
Lower the driver air bag connector access cover on steering wheel and disconnect the driver air bag module electrical connector. Connect the
special tool (41 8-F468) to the steering column harness side of the driver air bag module electrical connector.
5.
Disconnect the passenger seat belt pretensioner electrical connector and connect the special tool (418-F468) to the passenger seat belt pretensioner
harness side electrical connector.
6.
Disconnect the driver seat belt pretensioner electrical connector and connect the special tool (418-F468) to the passenger seat belt pretensioner
harness side electrical connector.