Tribute DX 4WD V6-3.0L DOHC (2002)
4.
Disconnect ABS module 25-pin connector by sliding lock mechanism out (towards passenger side of vehicle) and pulling connector off module.
NOTE:
When disconnecting the ABS module connector, be sure the blue connector lock stays engaged with the harness connector and does not remain
in the module. Remove it from the module if necessary and make sure the white 0-ring seal is properly installed.
5. Disconnect the speed sensor harness, then remove the two (2) harness retainers from the studs and position the harness above the air cleaner assembly
to provide access for inspection of the connector.