Tribute DX 4WD V6-3.0L DOHC (2002)
IMPORTANT SERVICE INFORMATION:
When performing the service pigtail installation, it is critical that the crimp tool and flameless heat gun be used. USING DIFFERENT TOOLS
MAY RESULT IN A POOR REPAIR.
PROCEDURE TO REPLACE VEHICLE HARNESS CONNECTOR
1.
Remove the tape and the convolute from the vehicle harness from the ABS module connector to 90 degree harness elbow".
2.
Measure 75 mm (approximately 3 in) from the end of the elbow towards the ABS module connector, then using suitable wire cutters, cut the
harness (all wires) to the same length.