Tribute DX 4WD V6-3.0L DOHC (2002)
WARNING: The air bag diagnostic tool is for restraint system repair only. Remove from vehicle prior to road use. Failure to remove
could result in injury and possible violation of vehicle safety standards.
10. Remove the air bag from the vehicle harness side of the passenger air bag electrical connector.
11. Connect the passenger air bag electrical connector.
12. Close the glove box.
WARNING: The air bag diagnostic tool is for restraint system repair only. Remove from vehicle prior to road use. Failure to remove
could result in injury and possible violation of vehicle safety standards.
13. Remove the air bag from the air bag sliding contact electrical connector at the top of the steering column.
14. Connect the driver air bag electrical connector.
1. Connect the driver air bag electrical connector.
2. Install the driver air bag electrical connector pin- type retainer into the steering wheel bracket.
15. Install the steering wheel access cover.
16. Connect the battery ground cable. For additional information, refer to BATTERY DISCONNECT.
WARNING: The air bag diagnostic tool is for restraint system repair only. Remove from vehicle prior to road use. Failure to remove
could result in injury and possible violation of vehicle safety standards.
17. With all the restraint system diagnostic tools removed, prove out the air bag system. For additional information, refer to DIAGNOSTIC
INSTRUCTIONS - AIR BAG AND SAFETY BELT PRETENSIONER SUPPLEMENTAL RESTRAINT SYSTEM (SRS).
18. Check the restraint system for correct operation.
Passenger Side