Tribute DX 4WD V6-3.0L DOHC (2002)
Tires: Testing and Inspection
Inspection and Verification
Warning
Inspection and Verification
Warning:
^
A vehicle equipped with a Traction-Lok (R) differential will always have both wheels driving. If, while the vehicle is being repaired, only
one wheel is raised off the floor and the rear axle is driven by the engine, the wheel on the floor can drive the vehicle off the stand or jack.
Be sure both rear wheels are off the floor. Failure to follow these instructions may result in personal injury.
Warning:
^
Never run the engine with one wheel off the ground, for example, when changing a tire. The wheel(s) resting on the ground could cause
the vehicle to move. Failure to follow these instructions may result in personal injury.
Warning:
^
Do not balance the wheels and tires while they are still mounted on the vehicle. Possible tire disintegration or differential failure can
result, causing serious injury and extensive component damage. Use off-vehicle wheel and tire balancer only. Failure to follow these
instructions may result in personal injury.
Be sure to follow the warnings when carrying out inspection and verification.
Road Test
Road Test
Verify the customer concern by carrying out a road test on a smooth road. If any vibrations are apparent, refer to NOISE, VIBRATION AND
HARSHNESS, under Suspension; Testing and Inspection.
To maximize tire performance, inspect for signs of incorrect inflation and uneven wear, which can indicate a need for balancing, rotation, or a
suspension alignment. Correct tire pressure and driving techniques have an important influence on tire life. Heavy cornering, excessively rapid
acceleration and unnecessary sharp braking increase tire wear.
Replacement tires should follow the recommended:
^
tire sizes
^
speed rating
^
load range
^
tire construction type
Use of any other tire size or type may seriously affect:
^
ride
^
handling
^
speedometer/odometer calibration
^
vehicle ground clearance
^
tire clearance between the body and chassis
^
wheel bearing life
^
brake cooling
Wheels need to be replaced when:
^
bent
^
dented
^
cracked
^
heavily corroded
^
leaking
^
they have elongated wheel hub bolt holes
^
they have excessive lateral or radial runout
Wheel and tire assemblies are attached by five wheel nuts
It is mandatory to use only the tire sizes recommended on the tire chart attached to the vehicle. Larger or smaller tires can damage the vehicle, affect
driveability, and require changing the speedometer calibration. Make sure wheel size and offsets match those recommended for the tire in use.
1. Inspect for signs of uneven wear that can indicate a need for balancing, rotation, suspension alignment, or damaged steering components.
2. Check tires for:
1
cuts
2
stone bruises
3
abrasions
4
blisters
5
embedded objects
