Tribute ES 4WD V6-3.0L DOHC (2002)
Electronic Brake Control Module: Description and Operation
Anti-Lock Brake Control Module
Note:
^
The 4x2 service replacement module cannot be interchanged with the 4x4 module. The service replacement 4x4 module is interchangeable with
the 4x2 module.
The anti-lock brake control module is mounted to the HCU.
It is an on-board diagnostic, non-repairable unit consisting of two microprocessors and the necessary circuitry for their operation. The anti-lock brake
control module monitors system operation during normal driving as well as during anti-lock braking.
Anti-lock brake module operation is as follows:
^
Under normal driving conditions, the microprocessor produces short test pulses to the solenoid valves that check the electrical system without any
mechanical reaction.
^
Impending wheel lock conditions trigger signals from the anti-lock brake control module that open and close the appropriate solenoid valves. This
results in moderate pulsations in the brake pedal.
^
The anti-lock brake module used in 4x4 application includes a G-sensor. It detects vehicle movement during a brake lockup event that is
transferred to other wheels through the powertrain.
During normal braking, the brake pedal feel is identical to a standard brake system.
Most faults that occur in the anti-lock brake system will be stored as a diagnostic trouble code (DTC) in the keep-alive memory of the anti-lock brake
control module. The DTCs can be retrieved by following the on-board diagnostic procedures.
