Tribute ES 4WD V6-3.0L DOHC (2002)
Brake Bleeding: Service and Repair
Master Cylinder Bleeding
Brake Master Cylinder-In-Vehicle Bleed
Warning:
^
Use of any other than the approved DOT 3 brake will cause permanent damage to brake components and will render the brakes
inoperative. Failure to follow these instructions may result in personal injury.
Warning:
^
Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid
contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water
and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.
Caution:
^
Do not allow the brake master cylinder degas bottle to run dry during the bleeding operation. Keep the brake master cylinder degas bottle filled
with the specified brake fluid. Never reuse the brake fluid that has been drained from the hydraulic system.
Caution:
^
Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.
Note:
^
When any part of the hydraulic system has been disconnected for repair or a new component is installed, air may enter the system, causing spongy
brake pedal action This requires the bleeding of the hydraulic system after it has been correctly connected.
1. Disconnect the brake outlet lines from the brake master cylinder and cap the lines.
2. Install short brake hoses to the master cylinder outlet ports with the ends submerged in the brake master cylinder degas bottle.
3. Fill the brake master cylinder degas bottle with DOT 3 brake fluid
4. Have an assistant pump the brake pedal until clear' bubble-free brake fluid flows from both brake hoses
