Tribute ES 4WD V6-3.0L DOHC (2002)
17. Screen now shows "Set ignition switch to the OFF position". Do this and press tick.
18. Screen now shows "Set ignition switch to the ON position". Do this and press tick.
19. Screen now shows "Set ignition switch to the OFF position". Do this and press tick.
20. Screen shows "Calibration has been loaded and checked". Press tick.
21. Screen shows" Re-install fuses for fuel pump and additional fans". Do this, then press tick.
22. Screen shows" Obtain a PCM label and fill in the PCM data shown with the date on the WDS screen. Install in the appropriate position. (New
label should be in the new PCM part box) Do this, then press tick.
23. Screen shows "start engine. Do not depress throttle". THIS IS INCORRECT!!!! You must follow the below procedure to start the vehicle:
-
Turn key ON (Count 3 secs. security is ON solid), Remove key.
-
Insert 2nd key, turn key ON, (security stay ON for 3 secs. goes out) Turn Key OFF. Then start engine. Turn OFF engine, remove key.
-
Both keys programmed.
24. Disconnect WDS from vehicle. PCM replacement procedure is completed.
