Tribute ES 4WD V6-3.0L DOHC (2002)
Body Control Module: Service and Repair
Programmable Module Installation - Using Backup Data
PROGRAMMABLE MODULE INSTALLATION - USING BACKUP DATA
NOTE: If using the NGS, select Module Configuration and Programming, then follow the screen prompts.
NOTE: Make sure to use the flash cable when programming calibrations or running a PMI routine on the PCM.
1. Select Programmable Module Installation on the NGS Tester.
2. Select Retrieve Module Configuration Old ECU. The NGS Tester will give you a message to reinstall the old module or to continue for backup
data. If the module to be replaced will not communicate or has incorrect data, continue and allow the NGS Tester to find backup data. If the NGS
Tester successfully retrieves the backup data, GO to Step 7 in this procedure. If the NGS Tester prompts you to contact the As-Built Data Center
for backup information, contact the As-Built Data Center and obtain the backup data for the vehicle and continue on.
3. After the As-Built Data Center backup data is obtained continue with the routine by entering the VIN number of the vehicle when the NGS Tester
prompts you to do so.
4. The NGS Tester will prompt you to enter the vehicle data. The vehicle data is listed on the As-Built Data Center sheet in the upper left-hand
portion, directly underneath the VIN for the vehicle.
5. The NGS Tester will prompt you to enter information for the module that needs to be reprogrammed. Enter all of the data that the NGS Tester
requests. If the NGS Tester requests information that is not listed on the As-Built Data Center sheet, press NO.
6. Follow the text screens until all pertinent data is entered and the module data is stored.
7. Select Restore Module Configuration - New ECU, and follow the text screens until successful.
8. Manually validate each customer preference item for correct setting. If necessary, ask the customer what setting would be their preference. Refer to
MODULE CONFIGURATION for the list of customer preference items.
