Tribute ES 4WD V6-3.0L DOHC (2002)
NOTE: Repair is made by installing a new part only If the new part does not correct the condition, install the original part and perform the diagnostic
procedure again.
1. Disconnect the battery ground cable and wait at least one minute. For additional information, refer to BATTERY DISCONNECT.
CAUTION: Use care when handling the seat and track assembly. Dropping the assembly or sitting on a seat not secured In the vehicle may result
in damaged components.
NOTE: Make sure to follow all steps and instructions in the removal procedure of the affected seat.
2. Remove he affected seat from the vehicle. For additional information, refer to DRIVER SEAT or PASSENGER SEAT.
NOTE: The driver seat removal is shown, the passenger seat removal is similar.
NOTE: Use care not to damage the center hole plug.
3. Pry out and remove the seat cushion adjuster handle center plug.
4. Remove the seat cushion adjuster handle.
1. Release the retaining tabs.
2. Pull and remove the seat cushion adjuster handle.
5. Remove the outboard seat cushion side shield.
1. Remove the seat backrest lever cover.
2. Remove the screw.
