Tribute ES 4WD V6-3.0L DOHC (2002)
NOTE: The driver seat safety belt buckle and pretensioner is shown, the passenger-side is similar
3. Remove the inboard seat cushion side shield.
1. Pull out to release the retaining clips.
NOTE: Note the wire harness routing for installation.
4. Release the pin-type retainers and separate the safety belt buckle and pretensioner electrical connector and wire harness from the seat.
NOTE: Do not handle the safety belt buckle and pretensioner in the area of the safety belt buckle and pretensioner cable or retaining nut.
Accidental pretensioner deployment could occur and result in personal injury.
5. Remove the safety belt buckle and pretensioner.
1. Using the special tool, remove the bolt.
2. Remove the safety belt buckle and pretensioner.
Installation
WARNING: Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag
module. This will reduce the risk of injury In the event of an accidental deployment.
WARNING: After deployment, the air bag surface can contain deposits of sodium hydroxide, a product of the gas generant combustion that is
irritating to the skin. Wash your hands with soap and water afterwards.
WARNING: Never probe the connectors on the air bag module. Doing so can result in air bag deployment, which can result in personal injury.
