Tribute LX 2WD V6-3.0L DOHC (2001)
4.
Turn the ignition key to the RUN position. Allow the ABS to carry out a preliminary self-check (indicated by illuminating the yellow ABS
warning indicator in the instrument cluster for approximately three (3) seconds).
^
If the yellow ABS indicator is not illuminated after three (3) seconds, proceed to next step.
^
If the yellow ABS warning indicator stays illuminated after the self-test, contact the Technical Assistance Hotline.
5.
Re-enter customer's radio pre-set stations and proceed to "C. CAMPAIGN LABEL INSTALLATION".
REPAIR PROCEDURE B
PROCEDURE TO REPLACE ABS MODULE
NOTE:
Module configuration or reprogramming is not required when installing a new ABS module.
1.
Disconnect the 2-wire electrical connector at the ABS module.
2.
Safely raise the vehicle on a hoist, then remove the four (4) ABS module screws and the ABS module.
3.
Position the new module and install the bolts.
Tightening torque: No more than 18 in-lbf. (2 Nm)
4.
Lower vehicle on hoist and reconnect 2-wire connector to the ABS module.
5.
Proceed to "PROCEDURE TO REPLACE VEHICLE HARNESS CONNECTOR".
