Tribute LX 2WD V6-3.0L DOHC (2001)
5.
Crimp each wire from the vehicle harness side.
6.
Using rosin core solder, solder only the vehicle harness wires to the butt splice connector.
7.
After soldering the wires, center each piece of heat shrink tubing over the splice. Then, using a flameless heat gun, shrink one piece of tubing at a
time until the adhesive flows out of both ends. Continue until all wires are insulated.
NOTE ON PROPER HEAT SHRINKING
The heat shrink tubing seals best if heat is applied to one end allowing time (only a few seconds) to begin the shrink process until you see the
adhesive flow out of the end. At this point, slowly move the heat source across the tubing shrinking it as you move towards the other end, finally
allowing adhesive to flow out providing a waterproof seal.
