Tribute LX 2WD V6-3.0L DOHC (2001)
8.
Install the supplied convolute tubing over the spliced area and secure with electrical tape. Apply tape to the entire length of the convolute and be
sure to secure the convolute to the elbow at one end, and as close as possible to the ABS connector on the other.
9.
Reinstall dress cover and use electrical tape to secure the cover at the same location where the original tie strap was removed. Apply dielectric
grease to the ABS module connector, position and connect the harness as follows:
a)
Reinstall dress cover.
b)
Use ONLY dielectric grease.
^
With the tip of the applicator tube snipped off, position the end of the tip between the four (4) large flat pins at the bottom of the ABS module
connector. Squeeze out enough grease to completely cover the four (4) flat pins.
