Tribute LX 2WD V6-3.0L DOHC (2001)
Valve Spring: Service and Repair
VALVE SPRING
Removal and Installation
1. Remove the roller followers. Refer to Camshaft, Lifters and Push Rods; Service and Repair.
See: Camshaft, Lifters and Push Rods/Service and Repair
Note: If air pressure has forced the piston to the bottom of the cylinder, any loss of air pressure will allow the valve(s) to fall into the cylinder. A
rubber band, tape or string wrapped around the end of the valve stem will prevent this from happening.
2. Pressurize the cylinder using compressed air.
3. Using the special tool, remove the key, retainer, and valve spring.
4. To install, reverse the removal procedure.
