Tribute LX 2WD V6-3.0L DOHC (2001)
5.
Remove the A/C line bracket nut and position the A/C line out of the way.
6.
Remove the bolts securing the front engine mount to the front engine support bracket and the right-hand apron.
7.
Raise the front of the engine approximately 13 mm (1/2 inch) by adjusting the support hook on the 3-bar engine support.
8.
Remove the front engine mount from the vehicle.
9.
Position the new front engine mount onto the vehicle, and install the three (3) bolts securing the mount to the right-hand apron. Do not tighten at
this time.
10.
With the aid of an assistant, align the front engine support bracket and mount, then lower the engine.
11.
Install one (1) new bolt to secure the front engine support bracket to the mount.
Tightening torque
103 Nm (76 ft-lb)
12.
Tighten the three (3) bolts securing the front engine mount to the right-hand apron.
Tightening torque
55 Nm (41 ft-lb)
13.
Position the A/C line, then install the A/C line bracket nut.
