Tribute LX 2WD V6-3.0L DOHC (2001)
5.
Disconnect A/C cycling switch electrical connector.
6.
Start engine.
WARNING:
Running the engine inside an enclosed area, such as garage, is dangerous. Exhaust gas, which contains poisonous carbon monoxide, could
easily enter the cabin. Loss of consciousness or even death could occur. Don't run the engine when inside an enclosed area.
7.
Open vehicle windows.
8.
Set the following:
^
Function selector switch in the Max A/C mode
^
Temperature at full heat
^
Blower at high speed
^
Engine running at normal operating temperature
9.
Run engine in this condition for twenty-five minutes. This will dry out the system.
10.
Turn ignition off.
11.
Disconnect and remove the blower motor and blower motor resistor according to Workshop Manual (section 07-40 CONTROL SYSTEM -
BLOWER MOTOR) (This provides ease of access to the evaporator core and eliminates the possibility of contaminating the blower motor and/or
blower motor resistor with Mazda A/C Cooling Coil Coating.)
12.
Shake the bottle of Mazda A/C cooling coil coating well (P/N 0000-77-570K-01) and attach it to applicator.
NOTE:
To avoid any possible damage, do not spill or spray this product on any interior surface (e.g. instrument panel) or material (e.g. carpeting).
13.
Connect applicator to compressed air. For effective treatment, use the full four (4) fluid ounces on one vehicle application.
14.
Insert applicator in opening of evaporator case and directly spray toward face of the evaporator core. Spray until bottle is empty, ensuring the
entire core is coated.
15.
Re-install blower motor resistor and blower motor immediately.
