Tribute LX 2WD V6-3.0L DOHC (2001)
a.
Crimp must be centered on each end of the butt splice.
b.
Wire insulation must not enter butt splice. Wire is flush with or extends slightly beyond the end of the butt splice.
c.
Wire is visible through the inspection hole of the butt connector.
7.
Position heat shrink tubing over the wire repair.
NOTE:
^
Overlap tubing on both wires.
8.
Use a shielded heat gun to heat the entire length of the heat shrink tubing until the hot melt appears from both ends of the tubing. Durability of a
heat shrink tubing splice is dependent on the hot melt that will appear from both ends of the tube. The hot melt forms an adhesive seal between the
wire insulation and the heat shrink tubing, which prevents air and moisture from entering the solder joint.
Disclaimer
