Tribute LX 2WD V6-3.0L DOHC (2001)
(For 3.0L vehicles with PCMs that have tear tag numbers of JYB2 or JYB3. For all other PCM tear tag numbers, refer to Procedure 2.)
Note:
When replacing a powertrain control module (PCM), the following items are required:
^
WDS with B20.12 or later software loaded.
^
Minimum two ignition keys for reprogramming PATS (be sure to ask customer for ALL spare keys).
^
Obtain new PCM part number AJ08-18-881F.
^
With old PCM still in vehicle follow procedure below.
Note:
When performing this procedure, if the WDS PTU is not docked and connected to 115V-120V, we recommend that a battery charger be installed on
the vehicle battery and turned ON to a maximum charge of no more than 20 AMPS to keep the vehicle battery up to capacity. If you exceed 20
AMPS it will damage the WDS PTU.
1.
Connect WDS DLC cable to vehicle's DLC connector (lower portion of dash in front of driver).
2.
Press "16 PIN", "All except those below", and then press tick.
3.
Screen shows cable hookup. Turn ignition switch to ON. Press Tick.
4.
Screen shows WDS communicating with PCM "progress bar" and "Operation in progress".
5.
Wait until WDS finishes collection of PCM information. (hard drive light quits flashing). Then the "Vehicle Specification" screen appears with
VIN # information. It asks you "Is this correct? Press "Yes" if information is correct.
6.
Screen appears to fill out R.O. information and mileage. Fill out information and then press tick. Or skip this by pressing tick.
7.
With screen showing "vehicle Specification", press "Tool Box".
8.
Another menu appears. Select "Module programming" then press tick. "Please Wait" appears.
9.
Then another menu appears. Select "Programmable module installation" then select "PCM" then press Tick.
10.
Screen shows "Set ignition switch to OFF (position 0)". Do this and press tick.
11.
Screen shows "Install a new module in vehicle". Replace the PCM with the new unit, then press tick.
12.
Screen shows" Remove the fuses for fuel pump and additional fans as this may cause interference and battery drain during the programming
process". Do this and press tick.
Note:
There are two 50 amp fuses (on 3.0L) labeled "Main Fan" and "Add Fan". Remove only the 50 Amp fuses to deactivate the fans. Fuel pump is a mini
fuse 20 amp (position 6) at front end of fuse box.
13.
Screen shows" Set ignition switch to the ON position". Do this and press tick.
14.
Screen shows "Downloading data" box with "progress bar". Please wait 2-3 minutes.
15.
Screen now shows" Set ignition switch to the OFF position". Do this and press tick.
16.
Screen now shows "Set ignition switch to the ON position". Do this and press tick.
17.
Screen shows "Set the ignition switch to OFF (position 0)". Do this and press tick.
18.
Screen shows "Calibration has been loaded and checked". Press tick.
19.
Screen shows "Re-install fuses for fuel pump and additional fans". Do this, then press tick.
20.
Screen shows "Obtain a PCM label and fill in the PCM data shown with the date on the WDS screen. Install in the appropriate position. (New
label should be in the new PCM part box) DO NOT FILL OUT PCM LABEL AT THIS TIME! Press tick.
21.
Screen shows "start engine. Do not depress throttle". THIS IS INCORRECT!!l!l You must follow the below procedure to start the vehicle:
