Tribute LX 2WD V6-3.0L DOHC (2001)
9.
Screen shows "To enable WDS to reprogram the PCM with the correct calibration: please enter the vehicle calibration number (7-digits) or the
catch word (4-digits)." Press TICK.
NOTE:
PCM engineering number, calibration number and catch word number are found on the PCM plastic electrical connector (i.e. PCM engineering
number 1L5F-12A650-MB, Catch Word number RIH1). The catch word number may also be found on the right front fender near where the
fender meets the cowl, or directly behind washer fluid bottle.
10.
On WDS, press the blue box next to "Tear Tag" to highlight it and enter the 4-character catch word number from the PCM. Press TICK, Please
wait.
11.
On Truck (B2300, B2500, B4000) screen shows "2001 MY 2002 MY" Select correct year.
B3000: Screen shows "Other" and "FFV". (if the 8th character of the VIN is a "V" Select "FFV", if the 8th character of VIN is "U", select "Other"
Tribute: Screen shows "Would you like to obtain backup configuration data for this vehicle?" Select "NO".
12.
Screen shows "Set ignition to OFF", - turn ignition OFF. Press TICK.
13.
Screen shows "Remove fuel pump relay and cooling fan relays to prevent electrical interference and battery drain".
Truck: There is no cooling fan relay. The fuel pump relay is located in position 50B in the engine fuse box.
Tribute: There are two-50 amp fused (3.0L) labeled "Main Fan" and "Add Fan". Remove only the 50 Amp fuses to deactivate the fans. Fuel pump
is a mini fuse 20 amp (position 6) at the under hood fuse box.
-
Remove fuses / relay as necessary for your vehicle. Press TICK.
14.
Screen shows "Is vehicle equipped with PATS: "YES or NO" Select YES for all vehicles except B2500, for B2500, select NO.
15.
Screen shows "Set ignition switch to ON" Turn ignition ON. Screen shows "Downloading data" with a progress bar. (takes approximately 2-3
minutes to complete).
16.
Screen shows "Set ignition switch to OFF", turn ignition OFF, press TICK.
Truck: Anti-lock Brake System box appears with choices: "Equipped, Non-Equipped", Select "Equipped". Press green TICK.
17.
Screen shows "Set ignition switch to ON" - turn ignition ON and press TICK.
18.
Screen shows "This module requires some configuration settings..." Press TICK.
19.
Screen shows "Set ignition to ON", Turn ignition ON. Press TICK.
20.
Screen shows "Selection Parameters":
NOTE:
