mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

Engine Controls/Emissions, Idle Dip & Intermittent Stall|Page 1959 > < Engine Controls/Emissions, Idle Dip & Intermittent Stall|Page 1957
Page 5
background image

6.

Inspection of Differential Pressure Feedback EGR (DPFE) Sensor Part Number

-

If DPFE sensor is stamped with part number 2F1E-9J460-AA or AB, proceed to Step 7 now.

-

If the DPFE sensor is stamped with part number YF1E-9J460-AD, check for a white dot on the sensor housing (note: white dot can be
anywhere on housing). If there is a white dot, proceed to Step 7 now. If there is not a white dot, replace the DPFE with part 1F22-20-302A.
Proceed to Step 7.

7.

Inspection of Mass Air Flow (MAF) Sensor Gasket

a.

Ensure the Mass Air Flow (MAF) sensor gasket is properly installed and not blocking the air stream by disconnecting the airbox and looking
inside the airbox towards the MAF sensor. If gasket is damaged, replace with part AJ03-13-211. Proceed to Step 8.

8.

Verify PCM Harness Integrity

Engine Controls/Emissions, Idle Dip & Intermittent Stall|Page 1959 > < Engine Controls/Emissions, Idle Dip & Intermittent Stall|Page 1957