Tribute LX 2WD V6-3.0L DOHC (2001)
3.
Reposition the harness to its original position, install the retainers to the studs to secure the harness and connect it to the ABS module.
4.
Reconnect negative battery cable.
5.
Turn the ignition key to the RUN position. Allow the ABS to carry out a preliminary self-check (indicated by illuminating the yellow ABS
warning indicator in the instrument cluster for approximately three (3) seconds).
^
If the yellow ABS indicator is not illuminated after three (3) seconds, proceed to next step.
^
If the yellow ABS warning indicator stays illuminated after the self-test, contact the Technical Assistance Hotline.
6. Re-enter customer's radio pre-set stations and proceed to C. CAMPAIGN LABEL INSTALLATION".
C.
CAMPAIGN LABEL INSTALLATION
Complete a Campaign Label" with the Recall 4507C written on the sticker and affix it to the vehicle's bulkhead. Refer to illustration under "A".
VEHICLE INSPECTION PROCEDURE".
