Tribute LX 2WD V6-3.0L DOHC (2001)
NOTE:
DO NOT spread the grease around the connector. Applying an excess amount of grease into the connector cavity will cause a "hydro lock"
condition which will not allow the connector to fully seat or lock in place.
10.
Reposition the harness to its original position, install the retainers to the studs to secure the harness and connect it to the ABS module.
11.
Reconnect negative battery cable.
12.
Turn the ignition key to the RUN position. Allow the ABS to carry out a preliminary self-check (indicated by illuminating the yellow ABS
warning indicator in the instrument cluster for approximately three (3) seconds).
^
If the yellow ABS indicator is not illuminated after three (3) seconds, proceed to next step.
^
If the yellow ABS warning indicator stays illuminated after the self-test, contact the Technical Assistance Hotline.
13.
Re-enter customer's radio pre-set stations and proceed to C. CAMPAIGN LABEL INSTALLATION".
REPAIR PROCEDURE D
1.
If the seals are not fully seated, reseat any seals not fully seated with a blunt tool.
