Tribute LX 2WD V6-3.0L DOHC (2001)
Air Bag Harness: Customer Interest
SRS - Air Bag Lamp ON/DTC's B1994 or B1998 Set
Restraints
08-002/05
2001-2004 TRIBUTE - SIDE AIR BAG
DIAGNOSTIC TROUBLE CODE (DTC) B1994 AND/OR B1998
APPLICABLE MODEL(S)/VINS
2001-2004 Tribute vehicles equipped with side air bag option
DESCRIPTION
Some 2001-2004 Tribute vehicles may exhibit an air bag warning lamp illuminating intermittently with DTCs B1994 (driver side, side mount air bag
circuit open) and/or B1998 (passenger side, side mount air bag circuit open).
This condition may be caused by a variation in the electrical continuity at connector S367 (driver side) or S337 (passenger side) at the body harness wire
terminal crimp.
A replacement Side Air Bag (SAB) Terminal Repair Kit is available to repair this concern. Refer to the instruction sheet included in the SAB Terminal
Repair Kit.
Customers having this concern should have their vehicles repaired using the following procedure.
REPAIR PROCEDURE
Install a SAB Terminal Repair Kit for each affected side air bag harness connector.
NOTE:
^
This service bulletin adds supplementary explanation to the instructions enclosed in the service repair kit parts package.
^
This repair procedure is specifically for this Service Bulletin only.
^
The soldering must be performed by skilled technicians who are appointed by the dealer service manager.
Before performing this repair, review all Workshop Manual safety WARNINGS and NOTES related to diagnosis and repair of the supplemental
restraint system (SRS), including those discussed below. If DTCs other than those noted above are observed, consult the Workshop Manual for
diagnostic procedures.
1.
Confirm the codes using WDS.
2.
Record all radio station presets so you can re-program customer preferences after repairs are completed.
WARNING:
^
The side air bag and pretensioner are pyrotechnic devices. Always wear safety glasses when repairing an air bag equipped vehicle and when
working on side air bag and pretensioner systems. Never probe a side air bag electrical connector. Doing so could result in side air bag and
pretensioner deployment and could result in personal injury.
^
To avoid accidental deployment and possible personal injury, the backup power supply must be carefully depleted using Steps 3 - 5 before
performing the repairs described in this Service Bulletin.
3.
Turn the ignition switch to the OFF position and remove key.
4.
At the Central Junction Box (CJB), located below the left side of the instrument panel, remove the cover and the Restraints Control Module
(RCM) fuses # ) 5 (5A) and # ) 7 (10A) from the CJB. For additional information, refer to the appropriate model year Workshop Manual and
Wiring Diagram.
5.
Disconnect the negative battery cable and wait one minute. Be sure to disconnect auxiliary batteries and power supplies (if equipped).
WARNING:
To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing or replacing any
