Tribute LX 2WD V6-3.0L DOHC (2001)
Seat Belt Buckle: Service and Repair
Safety Belt Buckle
Driver Side, Rear
SAFETY BELT BUCKLE - DRIVER SIDE, REAR
Removal and Installation
WARNING: All safety belt assemblies including retractors, buckles, front seat belt buckle support assemblies (slide bar), shoulder belt height
adjusters (if so equipped), child safety seat tether attachments, and attaching hardware should be inspected after any collision. All belt
assemblies should be replaced unless a qualified technician finds the assemblies show no damage and operate properly. Belt assemblies not in
use during a collision should also be inspected and replaced if either damage or improper operation is noted.
1. Pivot the seat bottom forward.
2. Pivot the seat backrest back.
3. Remove the safety belt and buckle assembly.
1. Position the carpet out of the way.
2. Using the special tool, remove the bolt.
3. Remove the safety belt and buckle assembly.
NOTE: Make sure the safety belt webbing is not twisted after repositioning the seat.
NOTE: Make sure that the safety belt and buckle are accessible after repositioning the seat.
NOTE: Make sure to tighten the bolt to specification.
4. To install, reverse the removal procedure.
5. Check the restraint system for correct operation.
Center and Passenger Side, Rear
SAFETY BELT BUCKLE - CENTER AND PASSENGER SIDE, REAR
Removal and Installation
WARNING: All safety belt assemblies including retractors, buckles, front seat belt buckle support assemblies (slide bar), shoulder belt height
adjusters (if so equipped), child safety seat tether attachments, and attaching hardware should be inspected after any collision. All belt
assemblies should be replaced unless a qualified technician finds the assemblies show no damage and operate properly. Belt assemblies not in
use during a collision should also be inspected and replaced if either damage or improper operation is noted.
1. Pivot the seat bottom forward.
2. Pivot the seat backrest back.
