Tribute LX 2WD V6-3.0L DOHC (2001)
1.
Buckle Cover Removal:
a.
Securely insert the hooked end of the buckle cover removal tool (SST # 604930700A) into the buckle assembly as shown.
b.
While sitting in the seat, firmly pull the tool up and away from the seat and center console to separate the safety belt buckle cover halves.
2.
Buckle Operation Check 1:
With the safety belt covers removed, verify safety belt buckle operation.
a.
Insert the safety belt tongue into the buckle. Make sure the buckle makes a "click" noise.
b.
Pull on the safety belt to make sure it is securely locked in the buckle.
c.
Push the buckle release button and make sure the buckle releases the safety belt.
d.
If the buckle fails to securely lock and retain seat belt, replace the inboard seat belt assembly and confirm that the new part functions
correctly.
3.
Buckle Cover Installation:
CAUTION:
Do not over-tighten the screws.
NOTE:
^
Verify that the plastic anti-rattle spring is in place on the lower cover prior to installation.
^
Replacement buckle covers go together more easily when the upper cover is positioned first (inboard side), and the lower cover positioned
second (outboard side).
a.
Install the new safety belt buckle cover with the felt patch on the passenger side buckle assembly. Install four (4) screws to secure the cover
and tighten the screws.
