Tribute LX 2WD V6-3.0L DOHC (2001)
d. Raise dust cover so that jounce bumper is accessible and apply 360 degrees to jounce bumper itself.
e. Slide dust cover and jounce bumper upward into its original location on strut.
f. Repeat procedure on other side of vehicle.
3. Dust Boot Replacement Procedure (vehicles built ON or BEFORE 1/13/2009):
a. Remove front strut according to MS3 online instructions or Workshop Manual (section 02-13 STRUT AND SPRING - FRONT
REMOVAL/INSTALLATION).
b. Disassemble front strut and replace dust boot with new part.
c. Apply Silicone Brake Caliper Grease and Dielectric Compound.
(1) Apply to entire length of chrome strut rod above jounce bumper and 360 degrees around rod.
(2) Apply to top and sides of uppermost part of dust boot.
d. Assemble front strut and install according to MS3 online instructions or Workshop Manual (section 02-13 STRUT AND SPRING - FRONT
REMOVAL/INSTALLATION).
e. Repeat procedure on other side of vehicle.
4. Verify repair.
PART(S) INFORMATION
WARRANTY INFORMATION
