190E 2.3 (201.028) L4-2.3L (102.985) (1987)
/l4-2.3l_(102.985)/Page-2197006.png)
22
Place clutch body (3) on wooden supports and press out bearing (6) using a drift 115 589 02 35 02. It is not necessary to remove the indentations
in order to remove the bearing.
Installing bearing
23
Align new bearing (6) accurately on bore of hub and then press in using the drift 115 589 02 35 02.
24
Punchmark bearing at 3 points offset at 120 °C for locking purposes. Do not punch too deeply or the outer race of the bearing may be deformed.
Do not use old indentations again.
Installing
