190E 2.3 (201.028) L4-2.3L (102.985) (1987)
Spacer
100 991 04 40
Latch plate
Supplied with restraint
Mounting screw
Supplied with restraint
Screw plug
123 997 00 31*
*To be used when child restraint is no longer required.
Subsequent Installation of Latch Plate For Tether Strap
NO. 160a
DATE:
August 1986 (Supersedes W.I. 160, October 1985) GRP. 91
SUBJECT:
SUBSEQUENT INSTALLAITON OF LATCH PLATE FOR TETHER STRAP (TO SECURE CHILD RESTRAINTS ONLY) MODELS 1
This work instruction now includes the installation procedure for model 124 vehicles.
NOTE:
All measurements are in millimeters
Model 107
Figure 1 - Anchorage Location in Model 107 (Use Passenger Side Only)
1.
Open the soft top storage compartment cover and unfold the top forward.
2.
Locate existing anchorage point (12 mm hole) through liner in rear wall of cargo space (directly behind the passenger seat) and punch a 12 mm
diameter hole in the liner (Figure 1).
NOTE:
The carpeting does not have to be removed.
3.
Fasten latch plate to existing anchorage point with mounting screw.
Models 123.133/153
Figure 2 - Location of Cutouts in models 123.133/153 X = Center
1.
Remove shelf below rear window (job no. 68-458).
2.
Remove perforated cutout in shelf insulation at either of the locations (right, middle, left) shown in Figure 2.
3.
Punch corresponding hole into the shelf carpeting from below using punch.
4.
Reinstall parts removed in step 1.