190E 2.3 (201.028) L4-2.3L (102.985) (1987)
/l4-2.3l_(102.985)/Page-1639003.png)
1. Take lubricating pressure rings (95) off input shaft.
Installation Note:
Insert lubrication pressure ring into the groove with grease so that joint is together.
2. Clamp assembly pedestal into the vise on both faces with plate facing upwards. Place gear set into the assembly pedestal with output shaft ahead.
3. Take out snap ring.
Installation Note:
After inserting, press snap ring into the groove with a screwdriver after the front gear set has been fitted on.
Assembly pedestal 126 589 00 35 00
4. Lift off front planet gear set (2).
5. Remove axial bearing (23) from planet gear set and examine.
6. Take off axial bearing (4) and input shaft (1).
