190E 2.6 (201.029) L6-2.6L (103.942) (1987)
/l6-2.6l_(103.942)/Page-2427004.png)
Shown with pop-up sliding roof holding angle screwed off.
10 Perform basic adjustment on lifting angle mechanism. For this purpose, insert adjusting gauges, part no. 124 589 17 21 00 left and 124 589 18 21 00
right into guide plate (lateral guide) and groove in lifting angle.
Attention: Pull off adjusting gauges only after pop-up sliding roof cover has been installed.
11 Install pop-up sliding roof cover. See: Sunroof / Moonroof Panel/Service and Repair
12 Unscrew cable from transport bridge.
13 Actuate pop-up sliding roof cover several times in all positions.
14 Check mark on holder of pop-up sliding roof headlining for marking on slide rail.
NOTE: If the mark is outside the notches on the slide rail, the cable must be adjusted. See: Sunroof / Moonroof Cable/Adjustments
