190E 2.6 (201.029) L6-2.6L (103.942) (1987)
Self-made tool
Bearing drift (lathed part), not required if a lever-operated hand press is used for assembly.
Removing and installing spring plate
Removing
1
Remove fan and fan hood.
2
Release and remove ribbed V-belt.
3
Hold spring plate in place using pin wrench 000 589 00 05 00 and slacken nut.
4
Screw puller 126 589 06 33 00 into spring plate and pull off spring plate.
Installing
5
Push spring plate onto compressor shaft and tighten nut to 16 + 1.0 Nm.