190E 2.6 (201.029) L6-2.6L (103.942) (1987)
Clockspring Assembly / Spiral Cable: Service and Repair
Remove/Install Slip Ring on Steering Wheel
On Steering Wheel until Introduction of Contact Spiral (06/93)
Removal:
-
Disarm SRS system.
-
Remove steering wheel and air bag.
-
Remove cable (55), with the rubber sleeve in the impact absorber (54).
-
Disconnect cables (58) and remove from the rubber sleeve in the impact absorber (54).
-
Unscrew screws (65).
-
On steering wheel version design 124, unscrew the 4 outer Torx socket bolts (66) (do not loosen center screw), remove impact absorber (54).
-
Remove wiper ring (70).
NOTE: When replacing the steering wheel it is essential to note which special equipment is fitted:
-
2 brass contact rings = standard (= horn rings)
-
4 brass contact rings = airbag
-
2 brass contact rings + 1 steering angle magnet ring (arrow) = 4MATIC, ADS
-
4 brass contact rings + 1 steering angle magnet ring (arrow) = Air Bag, ADS, 4MATIC
Installation:
-
Install wiper ring (70) at steering wheel.
-
On steering wheel version design 124, install impact absorber (54), screw in the 4 outer Torx socket bolts (66).
-
Screw in screws (65).