190E 2.6 (201.029) L6-2.6L (103.942) (1987)
/l6-2.6l_(103.942)/Page-1877002.png)
-
Using extractor/pulling-in equipment (010) 140 589 03 61 00 with set bolt (010b) and thrust piece (010a) or after market equivalent, pull rear axle
shaft flange (10) out of angular-contact ball bearing (8) and remove equipment.
Installation Note: Using extractor/pulling-in equipment (08a,08b,08c and 08e) 124 589 05 43 00 or after market equivalent draw rear axle shaft
flange (10) into two-row angular-contact ball bearing. (8).
CAUTION: During the pulling-in process, the thrust washer 124 589 05 43 00, part 03 (08c) or after market equivalent must fit tightly against
the bearing inner race (arrow). Be sure to use the 45 mm side of thrust washer.
