190E 2.6 (201.029) L6-2.6L (103.942) (1987)
/l6-2.6l_(103.942)/Page-1566004.png)
Installation Note: Using extractor/pulling-in equipment (08a, 08b, 08c and 08e) 124 589 05 43 00 or after market equivalent, pull two-row
angular-contact ball bearing (8) into wheel carrier (7) until this contacts the edge (arrow).
-
Install collet chuck (08f) 201 589 00 34 00 onto basic puller equipment (08g) 001 589 50 33 00 or after market equivalent and tighten with 55x65
open end wrench 140 589 00 01 00 or after market equivalent.
-
Using aluminum jaws clamp rear axle shaft flange in vise. Place thrust piece (010b) 000 589 03 34 00 or after market equivalent with large
diameter on rear axle shaft flange (10).
-
Clamp puller on bearing inner race, using puller 001 589 50 33 00 or 001 589 36 33 00 and collet chuck 201 589 00 34 00 or after market
