260E (124.026) L6-2.6L (103.940) (1988)
Model 124.333
8 Remove front propeller shaft (lb) from transfer case. Renew self-locking hex. nuts. Tightening torque 55 Nm.
9 Prior to sliding back propeller shaft, loosen vulcanized fitted sleeves of soft pull-push flexible coupling installed on transmission end by means of
a mandrel in flexible joint flange. For this purpose, use a cylindrical mandrel of 10 mm dia. and approx. 150 mm in length (not on models
124.333/393).
10 Remove propeller shaft from rear axle (arrows).