300CD (123.153) L5-3.0L DSL Turbo (617.952) (1982)
Installation
1. Align new bearing (6) exactly center in bore of hub and press-in.
2. Punch-mark the bearing at three points at 120° distance from each other. Do not punch to deep as outer race of bearing may be damaged. Do not
reuse old notches.
3. Insert magnet coil (9) into belt pulley (7).
4. Insert clutch (3) into belt pulley (7) and screw in new locks and screws (8) coating new screws with Loctite.
5. Install clutch assembly.
6. Install compressor.