300CD (123.153) L5-3.0L DSL Turbo (617.952) (1982)
Suspension Fluid Reservoir: Service and Repair
Removal and installation of pressure reservoir
Note:
For tightening pressure lines, use open box wrenches, but never normal open end wrenches, to prevent damage to line connections. A
special tool has been developed for better access to individual line connections, e.g. on level controller.
Use only solid copper sealing rings of specified dimension for hollow screws and screw connections. Always replace sealing rings on
principle
Removal
1. Drain pressure oil system.
2. Disconnect pressure line (B2 and B3) on pressure reservoir (4).
3. Loosen the three hex. bolts for attaching pressure reservoir to frame floor.