300CE (124.050) L6-3.0L (103.983) (1989)
/l6-3.0l_(103.983)/Page-616001.png)
Camshaft: Procedures
Replacing End Cover In Camshafts
-
Remove camshaft
-
Press cap (1) out with a screwdriver.
-
Clean hollow-drilled camshaft (26).
-
Check hole (B). See table for sizes.
-
Knock end cover (1) in with shop-made drift (2).
NOTE: Use new end cover (1). The end cover (1) must not sit at the end of the hole. It is important to adhere to the insertion depth (size E).
Table
Replacing Threaded Bush In Front of Camshaft
